LunarFlow R/C

General Category => Projects => Topic started by: chris on June 18, 2013, 23:31:02

Title: Blade 130X
Post by: chris on June 18, 2013, 23:31:02
Project 130X.

Had a Rakon DFC CNC head that was not square from the factory so I pounded on it with a hammer to make it straight.  :)

It appears to be possible to use an S107 tail motor to repair/replace the 130x servo motor.  The S107 motor is 4mm and the servo motor is normally 5mm so there is some extra space.  I used a piece of 1.5mm carbon rod to take up the extra space and it seems to work fine.  I may try to find some other method of holding the motor in place.  Also, rumour is that some S107 clones have 5mm tail motors.
SimplePortal 2.3.7 © 2008-2021, SimplePortal