Welcome to LunarFlow! This is a place for me to keep track of and discuss all my R/C projects. The forum area can be browsed or see below for a list of my projects. April 03, 2017, 23:53:37 by chris
Views: 15577 | Comments: 0 I'm building a gear indicator and information display for my CBR500R. It uses an Arduino Pro Mini, Nokia 5110 display, and hooks in to the Honda diagnostic connector under the seat. Protocol is a custom OBD k-line format. Here is some useful information on the protocol used. The first version I created used 2N7000 MOSFET's for the serial interface and it worked fine on a breadboard. However, before I could build the final physical version... March 12, 2014, 13:29:44 by chris
Views: 9700 | Comments: 0 This is a small 25mm by 30mm MultiWii board I started designing a while ago. I haven't had much time to refine or test it. I did create a prototype board but that's about it. The intent was to create a board small enough to be used on micro quads, helicopters, and planes. I'm providing the KiCad schematic and board layout here. July 17, 2013, 22:10:44 by chris
Views: 10127 | Comments: 0 The radio doesn't sit flat on the bottom when you set it down on a level surface. External TX module pins must be bent to fit modules. June 18, 2013, 23:31:02 by chris
Views: 9813 | Comments: 0 Project 130X. Had a Rakon DFC CNC head that was not square from the factory so I pounded on it with a hammer to make it straight. ![]() It appears to be possible to use an S107 tail motor to repair/replace the 130x servo motor. The S107 motor is 4mm and the servo motor is normally 5mm so there is some extra space. I used a piece of 1.5mm carbon rod to take up the extra space and it seems to work fine. I may try to find some other method of holding the motor in place. Also... May 24, 2013, 15:10:44 by chris
Views: 8975 | Comments: 0 Bought a cheap mCPX off eBay that had a broken 3-in-1. Fixed the 3-in-1 and converted to brushless using C05XL and super-FET XP-3A (double FET's). Main motor PWM signal (from resistor on back of board) is 1kHz. On the 9x using OrangeRX TX module throttle ranges from -72% (completely off) to +72% (solid full throttle signal). Pages: [1]
|
Honda motorcycle OBD/k-line interface gear indicator by chris
[April 03, 2017, 23:53:37] Re: Easily build simonk firmware on Windows by fantasy [March 19, 2016, 15:59:57] Re: Skyartec TX module for the 9x by SnappaGuy [October 22, 2014, 06:30:23] Re: Skyartec TX module for the 9x by SnappaGuy [September 23, 2014, 11:25:12] Re: Skyartec TX module for the 9x by chris [September 09, 2014, 11:43:07] |